Also CAT control doesn't work consistently using the CAT+ Tab comports.
I have found different radio control programs (HPSDR, Thetis, SDR Console) and versions of firm (Protocol 1 or 2) require different values for Audio IF. CW Skimmer Configuration with PowerSDRĬW Pitch 600 Hz - Radio CW tone is set to 600HZ I use RigCAT and the above referenced xml file with Fldigi and it works very well. You probably didn't think to look in the Flex folder, but remember that from a UI and external interface perspective PowerSDR mrX PS remains almost identical to the legacy PowerSDR version. If you wish to use RigCAT with Fldigi, the PowerSDR xml file is located here: In the list box you get select "Rig Control".įor Device select COMx, the other end of the software cable.Ģ. FLDigi works with the same interface as WSJT. Two Options for CAT control using FLDigi:ġ.
If you’re using Voicemeeter then there are gain controls in there too. Do you have the mode in HPSDR set to DIGU? If so, you’ll see the VAC1 receive and transmit adjustments on the main HPSDR screen. There is an audio level adjustment on VAC1 that you could try. The HPSDR level adjustment you need to look at is ‘RX1 AF’ rather than ‘Master AF’ because the latter only affects the audio into headphones/speaker, not VAC1. In WSJT-X, set the rig type to TS2000 and it should all work. You will also need a virtual COM programme to simulate the serial interface. Most people use Voicemeeter Banana in between HPSDR and WSJT-X to simulate the audio devices both ways. 
The way to connect them together uses the VAC1 output in HPSDR. WSJT-X works on the audio output from HPSDR so there needs to be a ‘virtual audio cable’ connecting the two bits of software together. Presumably you will use WSJT-X to do the FT8 processing, running on the same computer as HPSDR. 
You need to run HPSDR, the 100D won’t do anything without it (there is other SDR software, but HPSDR is the one generally used).
0 kommentar(er)
